Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All i wanted to know if Exchange 2010 with Encrypted MAPI supported with Cisco unity 7.0.2 ES 35 and above and if yes is this any where documented by Cisco.
Hi,I am desiging an MPLS network for an enterprise customer. He would like to have both L2 and L3 VPNs (EoMPLS and VPLS). Initially I thought of positioning ASR1000 but later I ruled it out as it does not support VPLS. So it comes down to 7600. Then ...
Hi,I am facing an issue with GW redundancy using HSRP. When the active link goes down, the switchover to standby link takes less than 300ms. But when the active link comes back, there is a packet drop for more than 1 sec. It seems to be for return tr...
I am facing the same issue with 8.6.2 SU3 and jabber 9.1.4but for version 8.6.2 20000 there is a bug which says if you upgrade it to specific ES it gets fixed, i have fixed for lot of customer.fixed version is 8.6.2.23059
Hi Jens, Thanks for your reply. Customer would like to have VCS CONTROL, MCU AND TMS behind Data Center firewall. I would like to know if this is recommended. Krishna.
Hi Dario,Thanks for your reply..HSRP has no control on return traffic. right? The issue I am facing here is the route is installed in the routing table as soon as the active link comes up. But the mac-address-table is not updated. This leads to packe...
