Hej.
I am replacing the standby server (secondary node) in a CCX 8.02su3 cluster because of hardware failure.
I can only find the procedure for replacing the primary node on cisco .com.
Here is what I attend to do :
1. Remove secondary node (server name) from primary node's www under System->Server
2. Take backup of primary node
3. Add secondary node (server name) in primary node's www under System->Server ( Same ip, sub etc as old secondary node but new mac)
4. Start installation on secondary node (with adding patches in the installation phase so the server comes to SU3 with the same)
5. Take full backup of cluster.
Don't if step 1 (and 3) is nessesary..
Can anyone please verify this procedure.
Thanks in advance
Thomas
