11-28-2018 10:25 AM - edited 03-15-2019 06:43 AM
Hi Folks,
Brand new to scripting here and my office has a request to change our existing script for one of our groups and add the pre-recorded message "all agents are currently busy" and have it play every 2 minutes after the initial one.
Any thoughts and suggestions are welcome!
Thanks!
11-28-2018 12:51 PM
11-28-2018 12:59 PM
Hi,
I already have the script I want edited open. Im trying to figure out how to add a pre-recorded greeting to my existing script to play every 2 minutes while someone is waiting for an agent.
11-28-2018 01:13 PM
11-28-2018 01:16 PM
Yup, I already have the recording in the correct format in English and Spanish.
11-28-2018 10:00 PM
11-29-2018 05:04 AM
Yup,
Have the recorded prompt in the correct folder for English and in Spanish.
11-29-2018 08:41 AM
Ok, excellent. So now, in the script editor, you need to locate the Select Resource step, this is the step which adds the caller to the Queue. If the caller does in fact need to wait for an Agent, then the code inside of the Queued branch of this step will be followed.
It might look something like this:
Select Resource from CSQ
Connected
End
Queued
QueueLoop:
Play Prompt (Queue Message)
Place Call Hold
Delay 120 sec
Place Call Unhold
Goto QueueLoop
And if it doesn't look quite like that, that is ok, but that's pretty basic and represents the logic you're going to need to play a prompt every 2 minutes.
Can you confirm that you can locate that area of your script? And hopefully, you only have one in there, as some people will place more than one in a single script, making long term administration harder. Let's hope that's not your case. Feel free to upload the entire script here too, or to screenshot the section.
11-29-2018 08:51 AM
11-29-2018 09:05 AM
11-29-2018 09:32 AM
11-29-2018 05:06 AM
Hi Anthony, I think he's referring to PCCE, not UCCX, at least based on the initial post.
If that's the case, probably would need to know how your ICM script looks, what you're using to play the hold message (Call Studio vs. Microapp) compared to this new prompt you're going to play, etc.
11-29-2018 05:22 AM
Bill, As far as I know its not PCCX.
11-29-2018 08:19 AM
11-29-2018 08:27 AM
Tags were my fault.
Its UCCX 10.5.1
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide