UCCE SNMP with Solarwind fail

[Shalid Kurunnan Chalil]

HI Guys,

Request your expertise advice on below;

I was configuring UCCE application level SNMP monitoring in Solarwind and facing some issues. we had followed the Cisco SNMP agent configuration part as mentioned in ucce snmp guide release 10.

we use the same string (snmp protocol version v2c) in solarwind , but its getting failed with authentication error. 

UCCE PG Cisco SNMP management configuration:

solarwind:- 

hope any one can guide us further this

Regards, 

Shalid

[Gergely Szabo]

Hi Shalid,

did/could you try to do a simple SNMP walk, querying for the value of a simple OID like 1.3.6.1.2.1.1.5 (hostname)? Does it give you an error message?

G.

[Shalid Kurunnan Chalil]

unfortunately the SNMP walk getting error as " %Failed to get value of SNMP variable"

[Gergely Szabo]

Hi, if it's a timeout then I am afraid it's either a network issue or a problem with authentication.

G.

[Shalid Kurunnan Chalil]

it works now. 

i was opted initially as anyhost in Cisco SNMP Management configuration under Community names. whenever we tried to authenticate from solarwind, its failed. 

but I added the IP address of the solarwind explicitly in Cisco SNMP Management configuration, it started working. but I wonder why it is not working when there is no restricted hosts.

Anyway thank you for your guidance. finally it worked.