05-06-2016 09:25 AM - edited 03-14-2019 04:04 PM
Just have a quick question, if there any way for calls going to UCCX for an internal queue (in this case the IT Help Desk) not to display the agent number/name on the calling phone? It would be much better if the trigger information remained or even the CTI port so that the user wasn't able to call back to the extension.
I understand there are some ways we could do this with partitions and CSS's but just not having it display in the first place would be a better solution.
Thanks
I'm not sure if it matters, but we are using 8845 SIP phones for both the agents and the calling users.
05-06-2016 09:55 AM
Hi John,
So you are saying as soon a caller dials the trigger and calls goes to queue ,answered by agent it is showing agent extension on the caller end?
I believe if you set alerting name for CTI port then it should show that number on calling device.
You can also configure display id in CTI port and check .
05-06-2016 10:25 AM
That's what I had assumed as well. I know I had done that with older UCCX servers and older phones and I thought that corrected the issue. In this case, the caller sees the CTI Port information and then when the agent picks up, they get their information. Not sure if this would be any different because these are SIP phones (I know the last time I did this is was using 79XX phones).
05-06-2016 11:54 AM
I am also using SIP phone's for calling party in the lab and it shows whatever is configured on CTI port on my calling device.
Can you take detailed Call manager traces to see what is happening between phone -CUCM-UCCX.
05-07-2016 11:56 AM
John what you are experiencing there is a default behaviour, no need to collect logs in this scenario. By default when the call is ringing on Agent Phone, the CTI port information will show up both on agent and caller since it is the CTI port that is actually doing the Consult Transfer to agent DN. As soon as agent picks up the phone, agent will see the actual ANI of caller and caller will see the DNIS. As far as you doing it with previous version of UCCX then you might be some how blocking the agent DN to show up on the caller screen after the call had been answered which I think you will need to do here as well. One thing here to note as well is that once the call is connected to the agent UCCX is out of the picture and any change to ANI/DNIS should be controlled by CM only.
In nutshell, the behavior you are experiencing there is a default one and I really dont think that can be changed since the agent DN is not the direct dialed entry but a consult transfer from the CTI port . I am not in front of my lab right now but when ever I will, surely test this thing and let you know if it is possible or not to apply the transformation in this particular scenario.
Regards
Deepak
05-20-2016 03:42 AM
02-04-2018 08:39 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide