cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4854
Views
5
Helpful
3
Replies

UCCX "The ID you entered was not found"

scooter817
Level 2
Level 2

       I wanted to know can someone tell me how do I add a user to be able to log into the supervior desktop software.

       He can log into the agent software fine but I was told that I need to add the user to the supervisors group. I've never  

       done that before and I wanted to know if someone could give me a some guideance on the matter.Thanks in advanc

       and have a great day.           

1 Accepted Solution

Accepted Solutions

Andrew Skelly
Level 7
Level 7

Login to CCX App Admin as an administrator.  Go to the Tools menu across the top then to User Management.


Find the user you are looking for and add the supervisor capability.

You can find this on Chapter 22

http://www.cisco.com/en/US/docs/voice_ip_comm/cust_contact/contact_center/crs/express_7_0/configuration/guide/uccx70ag.pdf

Please rate helpful posts by clicking the thumbs up!

View solution in original post

3 Replies 3

Andrew Skelly
Level 7
Level 7

Login to CCX App Admin as an administrator.  Go to the Tools menu across the top then to User Management.


Find the user you are looking for and add the supervisor capability.

You can find this on Chapter 22

http://www.cisco.com/en/US/docs/voice_ip_comm/cust_contact/contact_center/crs/express_7_0/configuration/guide/uccx70ag.pdf

Please rate helpful posts by clicking the thumbs up!

fb_webuser
Level 6
Level 6

You will also need to add the user as a primary or secondary supervisor for a team. Find teams in AppAdmin under Subsystems--->RmCm. If you do not add to the team as a Sup they will not be able to monitor the desired CSQ.

Hope that helps

---

Posted by WebUser Jeff Wilby from Cisco Support Community App

Greeshma Bernad
Cisco Employee
Cisco Employee

Hi,

You can also try out the steps mentioned in these documents for the same error message:

Check it out.