cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
948
Views
0
Helpful
0
Replies

VXML router config for CCB

Josh Kurtz
Enthusiast
Enthusiast

Hi All,

 

I am using an asr 1006 (RP2) as a cube router. I want to set up applications (for ccb) via dial-peers but dont think its fully supported (see below article... it's a bit vague though): 

 

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cust_contact/contact_center/customer_voice_portal/srnd/9_0/CCVP_BK_C7053373_00_cvp-9-01-srnd/CCVP_BK_C7053373_00_cvp-srnd_chapter_0111.pdf

 

I was wondering about the following 2 things:

 

1. Is it possible to configure an asr 1006 (RP2) as a vxml router to support this and 

2. If its not possible, is it possible to just set up a dialpeer to another router and just set up the other router to support ccb?

 

Thanks!

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers