I'm new to APIC-EM and still learning . Got my APIC-EM installed and discovered routers just fine. In Chrome Postman, i tried this - GET : https://apic-em-controller:8049/api/v1/topology/l3/ospfRESULT:{ "response": { "errorCode": "RBAC", ...
I have just begun to install and get acquainted with APIC-EM. I added a single 4500 to inventory. It seems to register fine, and I can see interfaces and their status, but in the Device Inventory I see ERROR-CONNECTION for collection status. It says:...
I see that this document recommends the ports that SHOULD be open on the Firewall or is it just SSH & SNMP?https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/application-policy-infrastructure-controller-enterprise-module/1-1-x/hardware-gu...
We will setup a iwan test enviroment with a apic-em (1.5).What is the requirement for a test hub site?Is it possible to create a hub site with isr4321?From the releasenotes i understand that just branch site is supported for this hardware.Is this a r...
Good Afternoon,I would like to ask if there's a way to pull Card and Module inventory details from the network devices from the APIC-EM ? I'm using API to get the inventory data for the devices but it would be great to have visibility to modules and ...
Hi there,Is there any documentation or is it even possible to turn our python scripts into an APIC-EM application (module) which can be installed into the APIC-EM instance like the command runner application:APIC-EM 1.4 Update - Part 1 CommandRunner...
Hi,i am proposing a Cisco ACI solution with APIC and Nexus 9336 Spine switches, can i have the Nexus 3164 as a leaf switch aggregating endpoint groups to the spine switch or must it be a Nexus 9K switch.regards,Isaac k.
Hi Everyone,I am trying out the Sandbox APIC-EM MiniLab no 1 today. I have an issue with discovering the devices. Some of the devices have been discovered normally, but some not. When I open the command on the device that is not discovered (in the ht...
Hello,I want to set a traffic direction (to Bidirectional) and assign a CONSUMER to a Custom app trough REST API, but the problem is I can not find the right API request that can show me Advanced Policy Settings?Has someone tried setting Advance Poli...
Hi There,We deployed a couple of Cisco C3560CX switch via APIC-EM P&P a couple of weeks ago, recently those switches status became 'unclaimed' after I upgrade APIC-EM from 1.3.2.37 to 1.4.3.1009. Please check the event of one of the switch below: ma...
Hi.I'm trying to use APIC-EM 1.4 to configure QoS on our new LanEdge/Core-devices that consist of Cat6840 in VSS. Those VSS'es use a dedicated port as dual-active detection with Fast-Hello. The network is not in production yet so I can play with as m...
We are currently working on a tool that will check information about a host and switch port configuration based on an IP or MAC and the host inventory.I have activated IPDT during the discovery process and there is a lot of data populated in the host...
Hi there,I have just gone to log into our APIC-EM instance and there is no webGUI presented.SSH'ing onto the VM and using netstat shows that it is not listening on TCP/80 or TCP/443 as I'd expect.I've restarted the grapevine service as I understood t...
I have a python application that runs incrementally to check for unplanned devices and depending on what hardware platform, and how many ports the device has it pulls the serial number and creates a device within a project. That piece works well howe...
