06-26-2017 02:23 AM - edited 03-01-2019 04:39 AM
We are currently working on a tool that will check information about a host and switch port configuration based on an IP or MAC and the host inventory.
I have activated IPDT during the discovery process and there is a lot of data populated in the host inventory, but there seems to be some hosts missing or not showing up.
How often is the data collected from the devices IPDT? Is it collected with the configuration poller job or is it a separate job.
Solved! Go to Solution.
06-26-2017 08:10 PM
Hi Daniel,
by default the controller polls network-devices every 25mins.
However, for hosts (user devices) you should enable SNMP traps which make the update happen when the interface changes state. This applies to switches and WLC.
06-26-2017 08:10 PM
Hi Daniel,
by default the controller polls network-devices every 25mins.
However, for hosts (user devices) you should enable SNMP traps which make the update happen when the interface changes state. This applies to switches and WLC.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide