Cisco Nexus 9k SNMP differences?

[j2sw]

We recently replaced a Cisco 9396 with a Cisco 93180YC-EX switch.  I copied much of the old config over including the SNMP.  Our management software will not poll the new 93180.  Nothing has changed except the switch swap.  Before I go down the road with the management software is there anything different on these two platforms that would cause this?

[balaji.bandi]

i would cross check the config and how the SNMP Source IP configured to pool from snmpwalk.

try manually snmpwalk to switch and enable some debug and see if the request really reaching the Switch ?