cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
15154
Views
6
Helpful
1
Replies
Highlighted

How to configure Nexus1000v for Hyper-v

hi,

    I want to konw how to configure Nexus1000v for Hyper-v

     I can configure the basic configuration just like the uplink is access port, the port connect to VMs is also access port.

     But I can't configure the Uplink as Trunk mode . I don't know how to do it .

    I want to achieve this scense:  2 physical NIC make a  port-channel as Uplink and my vitrual machine are in different vlans.

    Any one can  provide some configure examples?

    Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Cisco Employee

The configuration for Hyper-V is different then the way it works for ESX.

A lot of the configuration needs to happen within SCVMM and there are also some new concepts that get added to the VSM.

Have you looked at the install guides?

http://www.cisco.com/en/US/products/ps13056/prod_installation_guides_list.html

It's a good starting point. If you still need some help let me know and I might able to send you some additional info.

louis

View solution in original post

1 REPLY 1
Highlighted
Cisco Employee

The configuration for Hyper-V is different then the way it works for ESX.

A lot of the configuration needs to happen within SCVMM and there are also some new concepts that get added to the VSM.

Have you looked at the install guides?

http://www.cisco.com/en/US/products/ps13056/prod_installation_guides_list.html

It's a good starting point. If you still need some help let me know and I might able to send you some additional info.

louis

View solution in original post