04-29-2010 07:11 AM
Hello everyone,
i am running code 4.0(4)SV1(2)
i am trying to configure a port-profile for the system uplink (control & packet)
N1KDEMO(config)# port-profile system-uplink-control-packet
N1KDEMO(config-port-prof)# capability ?
iscsi-multipath Configure iSCSI multipath
l3control Set the L3control capability for this profile
i am not able to set the capability as uplink and the result was it end up being Veth instead of Eth
any help please?
thank you all
04-29-2010 07:18 AM
In 4.0(4)SV1(2)....you need to specify type ethernet which is same as using capability uplink in the SV1(1) code, so you would do :
N1KDEMO(config)# port-profile type ethernet system-uplink-control-packet
If you do not specify type ethernet it will default to vethernet
04-29-2010 07:22 AM
i tried that already:
N1KDEMO(config)# port-profile type ethernet UPLINK_ALWAYS
N1KDEMO(config-port-prof)# capability ?
iscsi-multipath Configure iSCSI multipath
l3control Set the L3control capability for this profile
04-29-2010 07:27 AM
You dont have to specify capability command in SV1(2) code.By specifying port-profile type ethernet UPLINK_ALWAYS you have already configued the port-profile to be capability uplink.
04-29-2010 07:32 AM
thanks Deepak
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide