Just been doing some more 1000v implementing, and currently build a port-channel with 2 interfaces, but for some reason the duplex its picking up is 'half' and I have tried to set it manually in the nexus1kv side, and I get the following message:
testsw01v(config)# int po5
testsw01v(config-if)# duplex full
ERROR: port-channel5: Incompatible Speed and Duplex settings on interface
I've tried to play around on the vCentre as well to manually set the duplex to full on the vmnics but it doesn't change the settings either.
Also we are using a HP Blade Chassis and Virtual Connect/Flexnic10 for the networking from the host perspective.
This is a known issue with FlexNIC & Virtual connect. Since the 1000v only recognizes standard NIC speeds (100MB/1G/10G etc), if you set it to a non-standard value this is expected behavior. This is ONLY a cosmetic issue - there is NO speed or performance impact. If you run an ifconfig from the ESX CLI, you should see the speed and duplex settings properly displayed.
You can also verify the correct operation by running esxcfg-nics -l.
Cisco® Nexus® Dashboard revolutionizes operations in today’s modern data-center environments. Join us to learn about the operational efficiencies realized from the seamless user experience of the dashboard and the powerful capabilities of Cisco Nexus Insi...
The HTML5 plug installation is successful. But I get the following error while I click on AVE. The other icons are showing up the results except AVE. Please let me know your SME thoughts on this error.
No VmmDomains Found
This session will help administrators and architects leverage SAN Insights Discovery to help understand the current status of their SAN fabric and help identify areas of opportunity for improvement. The attendees will learn the process, architecture, and ...