Integrated Security Platform

ISE device is running with version 2.7.0.356 we have Qradar for monitoring purpose and a syslog server as a remote log target. currently the requirement is, customer is planning to add another monitoring tool in their network. Does ISE supports multi...

Hello and good day, I try to play the software ise-1.1.1.268.i386 on the Cisco ISE-3355. After detecting the hard drive, I get the following message: Detected Cisco UDI (Unique Device Identifier):PID: ISE-3355-K9 , VID: V02, SN: KQ1F2BMError: Unable ...

In Firepower connection events, I see there are numerous connections that do not have any user. If I go to connection events and search the IP the user has, the user field shows no data. If I go to active sessions and search the same IP address, it s...

Hello;We are running a Firepower 2110 and it works fine so far.We have an official IP Address with NAT to one of our private Exchange CAS Server.I want that only the Port 80,443,587 are accessible from the Internet, what is the best way to restrict t...

Hi, I have a distributed ISE deployment with 2 PAN (PxGrid enabled) nodes, 2 MNT and 5 PSNs. I have integrated Check Point Identity Collector with ISE PxGrid Node. While integrating I exported Internal CA certificate from 'Primary PxGrid Node' which ...

Dear Experts, We use Cisco ISE for authenticating our VPN users.  Is there a report that can give the following details of the users authenticated by ISE:UsernameHostnameSession durationMac AddressRegards,Aniket

Hello! Does anyone have ANY documentation, Information, guidance, examples or ANYTHING that describes the steps & requirements to integrate ISE 4.2 with Cisco Security Manager 4.21 in place of using ACS?  I have looked but cannot seem to find anythin...

Dear all, I have a Firepower 6.4 with security intelligence enabled using Talos feeds. Now I wanna add new free TAXII feeds in order to test them. This TAXII feeds have to be in STIX format, of course. But when I look for open source TAXII feeds, I o...

Hi all,is there a way to save your view settings on the Cisco ISE Alarm Settings page?  I want to re-order the columns but cant see a way to save this preferred view. Also is there really no other alternative to going into each individual alarm that ...

Afternoon everyone, While attempting to configure one of our FP2130s for an offsite location connected into a Juniper through fiber only access, we discovered that our SFP ports are not engaging even when configured correctly. Doing a little more dig...

Hello,ISE2.7 patch 1There is a brand new deployment (primary/secondary node). That was the first time when I used "revert config procedure" and it stuck. I've been waiting for 4 hours without any luck. I bet it's still hanging there. I don't have acc...