05-09-2017 03:45 PM - edited 03-17-2019 10:17 AM
I found some 7960 phones that were never used in our bench stock. I configured them in CUCM but they continue to show "Registration Rejected". When I go to settings> status> status messages I see the following "TFTP File Not Found", "Load ID incorrect", and SEPDefault.cnf. I have uploaded ( under OS Administration> Software Upgrades>Install/Upgrade the following firmware from the cisco site: cmterm-7940-7960-sccp.8-1-2SR2.cop.sgn. Then I restarted TFTP services on the publisher and all 3 of the subscribers in the cluster but the device default setting for the 7960 phone never updates. It has the following firmware as the default: P0030801SR02. Is there something I'm missing here?
05-09-2017 03:59 PM
did you add the phone in CUCM as SCCP or SIP?
Please rate if useful
05-09-2017 04:53 PM
The phone is a SCCP.
05-09-2017 06:55 PM
Jeffrey,
not sure if you already have other 7940/60 on your cluster,
first check what firmware is currently on the phones you are trying to add, if these are the only 7940;s then you can change the device defaults (device>device settings>device defaults) and match the value there with what is already on the phones. alternatively, you could go into 7940 the phone and hard set the phone load name with what is already on the phone, that way it wont need to up or downgrade its FW.
please rate if useful
05-10-2017 10:02 AM
Thanks Dennis! This is what is so unexplainable. All other 7960 IP phones in our Domain have the default app load P0030801SR02. They register no problem. Its just these two phones that I have a problem with. These are new phones never used before. They were sitting in our bench stock and never deployed. What I also mentioned here is why didn't the new firmware replace the default load. I can't seem to understand why. I tried to reset to factory default. Hold down # key when headset , mute, and speaker buttons light up but these phones never go to the reset screen.
05-11-2017 10:16 AM
The problem with using these phones is explained here:
See:http://www.cisco.com/c/en/us/support/docs/field-notices/100/fn18246.html
We are now using CUCM ver 9.1.2. This fix does not work with this version. Sad to say we have to salvage these phones.
05-10-2017 05:20 PM
Dennis I found the link below that explains what the issue is. I am now using cucm ver 9.1.2 apparently this phone that shipped with the firmware P003AM30 loaded is unable to upgrade due to file size issue.
See:http://www.cisco.com/c/en/us/support/docs/field-notices/100/fn18246.html
Thanks for you help though.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide