10-25-2016 11:27 PM - edited 03-17-2019 08:28 AM
Hi Folks,
i think it will be a short answer for many of you but i can't find it.
After a upgrade from CUCM 8.6 to 11.5, our 88xx phones display incoming and outgoings calls to other parties like this:
---------------------------
CALLER NAME
NUMBER@HOSTNAME
---------------------------
We only want the Caller Name and the Number without any Hostname or Domain at the end.
I need some hints from you.
Thanks
Christian
10-26-2016 12:21 AM
Hi,
Please check the parameter below, it should be set to DN. If its set to DN already then i would suggest you to open a TAC case as it might be a new defect.
CUCM admin --> System --> Service Parameters --> Cisco CallManager --> Search for URI Dialing Display Preference --> Set it to DN
Aseem
10-26-2016 01:36 AM
Hello Aseem,
that was the Default, we did not touch it.
Christian
11-24-2016 11:49 AM
It is 4 weeks ago and i don't have any solution for this problem. The Service Parameter is set to "DN" and not to URI.
But on outgoing call e.g. external to 002233445566
The phone shows: 002233445566@cucm-pub-01
What is that? We have migrated and this is the second system that it was shown on 78xx, 88xx phones.
Any help is welcome!
Christian
08-23-2020 11:15 PM
Hi All
I have a similar issue. Is there a resolution?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide