88xx phone always use line 2

[wsteahr01]

Hi,

I am familiar with the "Always use prime line" setting on these phones. Is there a way to change "prime line" to line 2? Or another way to have outbound calls prefer line 2 instead? Thank you. 

[Abhay Singh Reyal]

Hope this below link helps

https://supportforums.cisco.com/discussion/13218711/88xx-enhanced-line-mode-always-use-prime-line-features

Regards

Abhay

Kindly rate all helpful posts !!!

[wsteahr01]

Thank you Abhay. That's sort of what I was looking for. 

Do you know if there's any way to register a phone with line 1 unconfigured and line 2 configured? On 8800 phones they are unprovisioned until line 1 is configured. 

[Abhay Singh Reyal · Accepted solution]

This is an expected behavior of SIP Phones, if you do not configure line 1 then it wont get registered as config file info for Line will be empty.

Find the below forum helpful

https://supportforums.cisco.com/discussion/12213011/8961-wont-register

HTH

Regards

Abhay

Kindly rate all helpful posts !!!