Add Prefix to local extension when making VOIP calls

[aadhu1]

Hi Guys,

  i would need help on the transilation rules for eg. the ip phone extension of mine which is 86128 should be seen to other end as 12386128 and that too i need only for one site office , i had tried transilation-rule which says rule 1 /^86.../ /123/ and added to dial-peer as transilation-profile outgoing "name" . could you please help on this one , cant figure out how to change the local extension .

[Dragan Ilic]

http://draganchilly.blogspot.com/2009/11/call-manager-and-call-manager-express.html

especially this:

CME advanced examples:

/^\(5..\)/ /1234\1/

- match numbers in 500-599 range and transform it in 1234500-1234599

HTH,
Dragan

[Carlo Poggiarelli · Accepted solution]

Hi.

Another way to translate could be

voice translation-rule 100

rule 1 /^5...$/ /123\0/

HTH

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"

[aadhu1]

Hi Dragan/Carlo,

I had tried both of ur transilation rules but its the same , my extension no: is not getting changed with the added prefix 123 to the other side call ... is there any other rule u guys can think of ....


Sent from Cisco Technical Support Android App

[Manish Prasad]

Hi ,

Can you paste the section of config which contains translation rule , profile and dial-peer.

Thanks

Manish

[aadhu1]

Hi Manish,

This is the config , you can see the translation rule 3 is the one for this purpose and is named as AUH-Test , and the profile have been added to dial-peer to where the prefix of the local extension should be changed and shown to the remote end with the added prefix .

voice translation-rule 1

rule 1 /^30/ /9/

rule 2 /973/ /9/

rule 3 /111/ /91/

rule 4 /444/ /90/

rule 5 /20/ /99/

rule 6 /^968/ /9/

!        

voice translation-rule 2

rule 1 /44/ //

!        

voice translation-rule 3

rule 1 /^86...$/ /123\1/

!        

!        

voice translation-profile AUH-Test

translate called 3

!        

voice translation-profile remove-prefix

translate called 1

!        

voice translation-profile uk-prefix

translate called 2

!        

!        

dial-peer voice 72000 voip

translation-profile outgoing AUH-Test

destination-pattern 72...

session target ipv4:10.28.2.2

codec g711ulaw

Thanks

Adarsh

[Carlo Poggiarelli · Accepted solution]

Hi Adarsh.

voice translation-profile AUH-Test

you have

translate called 3

should be

translate calling 3

HTH

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"

[aadhu1]

Many Thanks Carlo , that did worked , missed out the "calling" on that translate rule .

Thanks All for the help .