Peter -It depends on your

Peter_sgc_2 · ‎04-16-2015

Hello,

We have a UC560 on CCME and our Carrier has enabled a CPS service where we have to dial 16000 to access free calls onto our company mobile phones. However I would like to configure the system so that the Staff do not need to Dail 916000 in-front of the system and the CCME adds it automatically.

Is this possible? I don't really know much about the voice config via the CLI.....

Terry Cheema · ‎04-17-2015

Yes you can use voice translation rules to achieve this. You can apply the voice translation rule to the mobile dial peer pre-pending the digits you need.

Have a look at below link to understand the voice translation rules:

http://www.cisco.com/c/en/us/support/docs/voice/call-routing-dial-plans/61083-voice-transla-rules.html

-Terry

Please rate all helpful posts

Peter_sgc_2 · ‎04-17-2015

Hey Terry,

Thanks for that, I've take a look at the voice translation rules but this doesn't make a lot of sense to me.. I don't know anything about the Telephony-Services in the CLI

Where about would I add 16000 ?

voice translation-rule 4
rule 1 /^413$[0-1]$$/ /33383\1/
rule 3 /^413$[3-9]$$/ /33383\1/
rule 14 /^41$..$$/ /3338\1/
rule 15 /^....$/ /333800/
!
voice translation-rule 5
rule 1 /333801/ /4005/
!
voice translation-rule 6
rule 1 /333804/ /4111/
!
voice translation-rule 7
rule 1 /333805/ /4105/
rule 2 /333806/ /4106/
rule 3 /333807/ /4107/
rule 4 /333808/ /4108/
rule 5 /333809/ /4109/
!
voice translation-rule 8
rule 1 /333810/ /4110/
rule 2 /333811/ /4111/
rule 3 /333812/ /4112/
!
voice translation-rule 9
rule 1 /333800/ /4898/
!
voice translation-rule 10
rule 1 /333802/ /4102/
rule 2 /333803/ /4103/
!
voice translation-rule 11
rule 1 /333814/ /4114/
rule 2 /333815/ /4115/
rule 3 /333816/ /4116/
rule 4 /333817/ /4117/
rule 5 /333818/ /4118/
rule 6 /333819/ /4119/
!
voice translation-rule 12
rule 1 /333820/ /4120/
rule 2 /333821/ /4121/
rule 3 /333822/ /4122/
rule 4 /333823/ /4123/
rule 5 /333824/ /4124/
rule 6 /333825/ /4125/
rule 7 /333826/ /4126/
rule 8 /333827/ /4127/
rule 9 /333828/ /4128/
rule 10 /333829/ /4129/
!
voice translation-rule 14
rule 1 /333830/ /4130/
rule 2 /333831/ /4131/
rule 3 /333832/ /4132/
rule 4 /333833/ /4133/
rule 5 /333834/ /4134/
rule 6 /333835/ /4135/
rule 7 /333836/ /4136/
rule 8 /333837/ /4137/
!
voice translation-rule 21
rule 1 /333838/ /4894/
!
voice translation-rule 24
rule 1 /333813/ /4895/
!
voice translation-rule 25
rule 1 /333839/ /4896/
!
voice translation-rule 410
rule 1 /^9$.*$/ /\1/
rule 15 /^....$/ /01225636150/
!
voice translation-rule 411
rule 1 /^9$.*$/ /ABCD9\1/
!
voice translation-rule 412
rule 1 /^ABCD$.*$/ /\1/
!
voice translation-rule 422
rule 1 /^ABCD909[01]......../ //
rule 2 /^ABCD9090[89]......./ //
rule 3 /^ABCD9098$.*$/ //
rule 15 /^ABCD$.*$/ /\1/
!
voice translation-rule 1000
rule 1 /.*/ //
!
voice translation-rule 1111
rule 15 /^....$/ /01225636150/
!
voice translation-rule 1112
rule 1 /^9/ //
!
voice translation-rule 2001
rule 1 /333800/ /4898/
rule 2 /333839/ /4896/
!
voice translation-rule 2222
rule 1 /^909[01]......../ //
rule 2 /^9090[89]......./ //
rule 3 /^9098$.*$/ //
!
voice translation-rule 3265
rule 1 /$^..........$$/ /90\1/
rule 15 /$^ABCD$$/ /ABCD\1/
!
!

kkoeper12 · ‎04-17-2015

Could also use the Prefix command on the dial-peer to prefix 16000 to the number you are sending the carrier.

Peter_sgc_2 · ‎04-17-2015

Hey kkoeper12,

That sounds easier... how would I do that.... ??

kkoeper12 · ‎04-20-2015

Peter -

It depends on your current dial peer config but in general it would be:

dial-peer voice 1 voip

destination-pattern 9[2-9]......

prefix 16000

Adding a Dial Prepend....