after hour configuration not requesting PIN

[W S H FERNANDO]

Hi

I have done the after-hour configuration with CME 8.8, phone number is blocked using after-hour config, but its not requesting a PIN to by pass the blocking,  I have entered a PIN command under ephone also.

part of the config is bellow.

!

telephony-service

max-ephones 100

max-dn 100

ip source-address x.x.x.x port 2000

system message abc

time-zone 39

max-conferences 8 gain -6

web admin system name admin secret xxx

dn-webedit

time-webedit

transfer-system full-consult

login timeout 1 clear 23:00

after-hours block pattern 1 0777662756

after-hours day Sun 00:00 23:59

after-hours day Mon 00:00 23:59

after-hours day Tue 00:00 23:59

after-hours day Wed 00:00 23:59

after-hours day Thu 00:00 23:59

after-hours day Fri 00:00 23:59

after-hours day Sat 00:00 23:59

after-hours override-code 1234

after-hours login http

create cnf-files version-stamp 7960ccccc

ephone  14

device-security-mode none

mac-address 0023.049A.72B8

after-hours login http

type 7911

button  1:14

pin 4321

!

Please help to resolve this issue.

Regds

$

[Chris Deren]

Remove

after-hours login http

from your configuration as this commands does the following:

Usage Guidelines

Use this command to log in to a phone to unblock the after hour block and enable the phone user to place outgoing calls regardless of whether the outgoing called number matches the defined pattern of digits during the call blocking periods.

When you configure after-hours login http command, you will experience slightly different login behavior compare to the current one. This difference is because the after hours login mechanism is enhanced due to some UI limitation in the current model. By default, after-hours login http is not applied, which mean user will be using the existing after hours login mechanism.

By default, all IP phones in a Cisco Unified CME system are subject to call blocking if the Call Blocking feature is configured.

If you use an ephone template to apply a command to a phone and you also use the same command in ephone configuration mode for the same phone, the value that you set in ephone configuration mode has priority.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_a1ht.html#wp1130278

HTH,

Chris