cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1270
Views
0
Helpful
2
Replies
Highlighted
Beginner

Alcatel 4400 - Cisco H323 VG

Hi,

We need to integrate an Alcatel 4400 PBX with our Cisco CallManager 6.1 using a Cisco 2811 H323 VG.

We will use an Alcatel PRA-2 card on the Alcatel PBX and an E1 card on Cisco VG.

The link will use QSIG.

1- What kind of cable should we use? (straight, crossed, 1-2-4-5...)

2- Is there any updated doc detailing the Cisco and Alcatel configuration?

3- Is there any special requirements for this integration, any recommendations...?

Thanks for your help.

Everyone's tags (5)
2 REPLIES 2

Re: Alcatel 4400 - Cisco H323 VG

Hi there, did you have any luck with this?

Beginner

Re: Alcatel 4400 - Cisco H323 VG

Hi,

Yes we did it.

First, one of Alcatel guys must do Alcatel config for you.

Second, we put a Cisco VG and connected the Alcatel PBX via an E1 (1/2/4/5 connection).

Please find the configuration of the controller :

interface Serial0/0/1:15
   no ip address
   encapsulation hdlc
   isdn switch-type primary-qsig
   isdn overlap-receiving
   isdn incoming-voice voice
   isdn negotiate-bchan
   isdn sending-complete
   no cdp enable

Attached a Cisco doc describing the Alcatel configuration steps.

Good Luck !

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards