Automatically Select Line other than 1 for outbound calls

[T00722700]

Is there a way to automatically select Line 4 when dialing out on an 8851 phone registered to a CUCM 11.5?  Or, is there a way to NOT select Line 1 automatically when calling out?

Automatically Use Prime Line is disabled, and Revert to All Calls is disabled.

thanks,

Michelle

[Sadav Ansari]

If you are using CME then you can apply below command in your telephony-service configuration.

auto-answer answer-incoming

If you are using CUCM the it’s not possible you have to select the line to dial the number otherwise it will always use line 1 as primary.

Pls rate if its “Helpful”. If this answered your question pls click on “Accept as Solution”.