Basic requirements in designing a VoIP Network
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-29-2016 07:10 AM - edited 03-17-2019 07:23 AM
Hi Everyone
Could someone please tell me what are the basic and necessary requirements while designing a VoIP Network ?
I know about QoS thing, HA and other stuff but I need very basic and necessary info like :
1. What would be the minimum required Bandwidth ?
2. What are the best practises for the same actually ?
Regards
Rohit
- Labels:
-
Other IP Telephony

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-29-2016 07:57 AM
Rohit,
It's not a question that can be answered withing one line or event one page as there are books around this subject.
I guess good start would be:
http://www.cisco.com/c/en/us/solutions/enterprise/design-zone-collaboration/index.html
Leszek
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-29-2016 08:36 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-29-2016 09:00 AM
Thanks Chris for your reply too..... I have read SRND already. But I wanted to know what if I need to answer the same w.r.t. the interviews and Questionnaires.
But thanks again for your reply and response. I apreciate it.
Regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-29-2016 08:58 AM
Thanks Lezsek for your reply.......
and yes you are right it cannot be answered in one line or one page, but I just wanted to know the main factors and points involved in it. I have read the SRND for the same also as well as administration guide too, but I wanted to know w.r.t. the interview stuff actually.
Anyways thanks again for your response.
