cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
551
Views
0
Helpful
2
Replies

BLF-SPEED-DIAL STILL NOT WORKING

isaaco001
Level 3
Level 3

Dear Community,

I have configured the blf-speed-dial on some phones running on sip i.e 7945 and was working just fine.After sometime the lights stops blinking.Despite by efforts to troubleshoot this by removing the latest configs that i did which i thought stopped the lights working,still there was the same issue.The last configs that i did was on class of restriction.I have attached the configs for blf where extension 121 is monitoring 120(bfl.txt running config) and also 103 monitoring 122 (debugs output) :

debug presence all
debug voice ccapi inout
debug ccsip all
debug voip application all

and my running config(blf)

show presence subscription

Presence Active Subscription Records:
=============================================

show subscription sip
ASNL Active Subscription Records Summary:
=========================================

Number of active subscriptions: 0


Client EXPIRES(sec) EVENT
====== ============ ======
121 0 presence
121 0 presence
150 0 presence
103 0 presence

Some new sessions have started during the show command.
The current number of active subscriptions = 4

show subscription asnl session active
ASNL Active Subscription Records Details:
=========================================

Number of active subscriptions: 0

No active subscriptions found.

show subscription local
ASNL Active Subscription Records Details:
=========================================

Number of active subscriptions: 0

No active subscriptions found.

Please advice how i can best troubleshoot this problem.Any suggestions are welcomed.

Thank you.

2 Replies 2

aaavvvmmm
Level 1
Level 1

Hi,

BLF on a router takes a lot of resources. I think you router is exhausted. I had a similar problem. What type of router you have? I  believe you over the MAX BLF the router can handle.

BR,

Aviram

Hi,

Its a 2951 voice router.However i am not sure how many max blf it can handle,i will check with configs again.I think i may have to remove redundant configs especially on the dial-peers and hope it works.I will keep you updated.Thanks,you've given me a good idea for troubleshooting the problem.

Regards,

Isaac.