BLOCK INCOMING CALL IN CUBE BEFORE SENDING TO CUCM

[Jean Paul Enerst]

Hi Guys,

I have done this before but it has been a while since then... Anyways, there are a few marketing numbers that our AR dept wants me to block, i don't want to do it in CUCM. I think it is more effective to drop the call as soon as it gets to the CUBE.

Here is what i tested and it didn't work... Perhaps another set of eyes can shed some light.

Let's say i want to block all calls coming from PSTN number : 76074094XX. Want to block the call on CID for number 76074094XX aka any call from that # should be blocked.

1. voice-translation rule 760

rule 1 reject /76074094XX/

2.  voice translation-profile  Block-incoming

     translate calling 760

3. Then apply the translation-profile to the Incoming Dial-peer from SIP provider

dial-peer voice 760 voip
 description Incoming FROM SIP-TRUNK
 translation-profile incoming IN-ITPS-CALL
 call-block translation-profile incoming Block-incoming
 call-block disconnect-cause incoming call-reject
 session protocol sipv2
 incoming called-number .
 voice-class codec 1
 dtmf-relay rtp-nte
 ip qos dscp cs5 media
 ip qos dscp cs5 signaling
 no vad
!

Thanks,

[Chris Deren]

Change rule 1 reject /76074094XX/ to rule 1 reject /76074094../

[Jean Paul Enerst]

Hi Chris,

Thanks for the reply... XX has replaced the last two digit, just for privacy concerns.

But i my config i have added the full ten digits in the rule ans still NADA. What i am thing is the direction of that i apply it in voice traslation-profile. It's calling i wonder shall i change it to translate called 760.

And thanks again for the input.

[Chris Deren]

Can you provide "debug ccsip messages" and "debug voice translation"?

[Jean Paul Enerst]

Hi Chris,

Thanks for the help... But the  issue has been fixed.

It seems the dial with coming number as a (.) was to general. I've added another DP with the exact number on which i want to block and it works ax expected.

Cheers 

[Chris Deren]

Excellent. Thanks for the update.