Branch mobile calls through HQ E1

[jacobwminja90]

Help on how to direct branch calls to use HQ E1 for mobile calls, i have tried to direct it via Local route group to HQ gateway without success,

I have branch and hq which are on different locations, I want mobile calls from branch to be routed to hq via sip trunk and I want to use e1 for outgoing&incoming mobile calls

[Devansh]

could you please elaborate you question. are you trying to send the HQ calls via E1 using Mobile calls. are you using different E1 for other calls?.

[jacobwminja90]

I have branch and hq which are on different locations, I want mobile calls from branch to be routed to hq via sip trunk and I want to use e1 for outgoing&incoming mobile calls

[Jaime Valencia]

The incoming part, you'll have to work that out with your telco, that's not something you control.

The outbound part, is as Jitender explained, this is CSS/partitions and a RP/RG, are you sure you're hitting the right route pattern?

[Jitender Bhandari]

Hi,

Sounds straightforward to me.

1) Create a Route Pattern to match the mobile number.

2) Create a Route List and a Route Group.

3) Put the remote Gateway in the Route Group and Put the Route Group in the Route List.

4) Point the Route Pattern create in Step 1 to Route List created in Step 2

(Rate if it helps)

JB

[jacobwminja90]

I have tried that still the same problem