04-07-2011 06:27 AM - edited 03-16-2019 04:23 AM
Hi,
i have probléme with Bri NT/TE, Layer 2 set from state "MULTIPLE_FRAME_ESTABLISHED" to "TEI_ASSIGNED" During the call after 2 mn.
this configuration of interface Bri
interface BRI0/2/0
no ip address
no ip mroute-cache
no logging event link-status
isdn switch-type basic-net3
isdn timer T310 30000
isdn point-to-point-setup
isdn incoming-voice voice
isdn sending-complete
isdn static-tei 0
ISDN BRI0/2/0 interface
dsl 8, interface ISDN Switchtype = basic-ts013
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 0, Ces = 1, SAPI = 0, State = TEI_ASSIGNED
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 8 CCBs = 0
The Free Channel Mask: 0x80000003
04-07-2011 06:41 AM
Could you collect output for "debug isdn q921" and post it. That will explain what is happening at layer 2.
04-07-2011 07:17 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide