How i can call directly without pressing 0 or 9 on the phone ?? i have h323 protocol
this is POTS configuration in My gateway :
dial-peer voice 11 pots
progress_ind setup enable 3
progress_ind alert enable 8
progress_ind progress enable 8
progress_ind connect enable 8
All route Pattern
9.18xxxxxx without predot
how i can do it without pressing 9 or 0 , just remove 9 from gateway and dial-peer and thats all ???
Second Question is :
I have Fake Extenstions (not DID extension) , i need somebody has a fake extenstion call out side , will do through some DID extesntion , i will use EXternal mask or translation pattern or num-exp , Note : SIP trunk using from TElco side (not E1 or FXO ) from my side
fake extention : 401 , when call out side. go through
For the first Q: Yes, removing 9 from the dial-peer will do the trick, but this is not recommended as when you have a pattern with T, it means match any number of digits, which means if anyone would dial an incoorect number (Internal Ext) the router would try to send a call through the voice gateway. If you plan to use have call routing seting without using a 9 or 0 dial, you should have dial-peers setup to match specific 10 digit for LD and 7 digit for Local starting with [2-9]. You'd need a similiar dial-peer for Intl calls.
Yes, you can do a num-exp compared to translation-rule. Though if you want to have a better control on the translation it you might want to use translation-rule. A thread you could read to get more info on both of them:
RTMT alert are triggered when the services configured to collabaration servers. Some of the alert are triggered while triggered from the alert. Voice and Video AlertsThe following list comprises the preconfigured Voice and Video alerts:• BeginTh...
Cisco Champion Radio · S7|E46 From Efficiency to Resiliency with Cisco IT
The COVID-19 pandemic set a new high bar for organizations and their need for increased business resiliency. When the pandemic hit, thousands of organizations around the world foun...
Hi,I'm facing problem while trying to login Cisco Prime License Manager. When I type login and password it show me “Invalid Username or Password. Please try again.”. But login and password correct. I reset password but it is show the same error. &nbs...
Hello everyone,after updating the CUCM to the last version 184.108.40.20600-97 a customer complains about errors on an applications server. These errors did not occur before the update. Phones can no longer be controlled. Only after a reinitialization of the ...
Hello, We have been facing issues with backup of drfcomponent.XML & Processnode.XML files to our backup servers during scheduled Backup in our CUCM 11.0 servers.We have been using Titan FTP server for Backup. I see error on backup statusERRO...