03-13-2012 01:26 PM - edited 03-16-2019 10:06 AM
Hi:
I have 2 CME in remote sites and I can't place a call between them, when I use codec g711ulaw the call is sucessful but with codec g729r8 not permit the call. The call disconnect cause is:
Last Disconnect Cause is "41 ",
Last Disconnect Text is "bearer capability not implemented (65)",
Why not permit de codec g729r8?
What can I do to place a call with codec g729r8?
Thanks a lot
Rogelio Medina
03-13-2012 02:20 PM
You did not post config, so it's impossible to say what it's wrong, but likely it's dial-peers.
03-13-2012 02:59 PM
03-14-2012 05:17 AM
Hi Rogelio,
Could you please post the full config?
Transcoding is registered properly on the gateway?
03-14-2012 05:38 AM
Is the call between 2 Cisco IP phones? If so no transcoder should be needed and all you need to do is make sure you create a dial peer with incoming called-number defined that is referencing the codec class.
HTH,
Chris
03-14-2012 12:54 PM
Hi Jefferson and Chris:
I can't post the complet config, tell me what part of this needed. The trancoding resources are properly registered:
Transcoding Oper State: ACTIVE - Cause Code: NONE
Active Call Manager: 172.16.110.1, Port Number: 2000
TCP Link Status: CONNECTED, Profile Identifier: 1
Reported Max Streams: 6, Reported Max OOS Streams: 0
Supported Codec: g729r8, Maximum Packetization Period: 60
Supported Codec: g711ulaw, Maximum Packetization Period: 30
Supported Codec: g711alaw, Maximum Packetization Period: 30
Supported Codec: g729ar8, Maximum Packetization Period: 60
Supported Codec: g729abr8, Maximum Packetization Period: 60
Supported Codec: rfc2833 dtmf, Maximum Packetization Period: 30
Supported Codec: rfc2833 pass-thru, Maximum Packetization Period: 30
Supported Codec: inband-dtmf to rfc2833 conversion, Maximum Packetization Period: 30
Yes, are Cisco IP Phone, the two remotes sites are connected with ipsec tunnel and the voice is sent through it.
eRm
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide