03-01-2011 02:17 AM - edited 03-16-2019 03:41 AM
Hello,
I am facing a problem in routing calls from voicegw to CUCM,
the following configurations was implemented on voicegw:
dial-peer voice 787499872 voip
preference 1
destination-pattern 0787499872
voice-class codec 99
session protocol sipv2
session target ipv4:192.168.70.21
session transport udp
dtmf-relay rtp-nte h245-signal h245-alphanumeric
no vad
dial-peer voice 78749987 voip
preference 1
destination-pattern 0787499872
voice-class codec 99
session protocol sipv2
session target ipv4:192.168.70.22
session transport udp
dtmf-relay rtp-nte h245-signal h245-alphanumeric
no vad
on CUCM side, I have added the number 0787499872 as a line in extension.
is there anything wrong or missing in my configurations?
03-15-2011 09:43 AM
Senthil ...
I have modified the dial-peer .. I omitted the "0" .. now the call is routed to the CUCM, however, the call is released with "your call cannot be completed as dialed ... " announcement, I doubled check the configuration from CUCM, and everything seems normal:
I added a Line with the dialed-number : ' 787499872'
when I checked the Route Plan, I found two Pattern/Directory numbers:
787499872
0787499872
Any ideas?
03-16-2011 10:39 AM
Hi Yousef
Its great, Finally the call reached CUCM,
Now I would suggest you to check whether is this number 787499872 you added is on the same PARTITION where this number is 0787499872.
Please check you might have CSS Group assigned to you H323 Gateway that may not have access to the number 787499872.
Regards
Senthil
03-14-2011 02:16 PM
Hello Yousef,
I hope you are doing great,
I would like to confirm if you can provide a route plan report from the CUCM with the number you are trying to dial.
Also if you have the gateway added as h.323 on the CUCM remove the sipv2 from the dial peer since they are different control protocols.
Please provide me the output of the following command:
"debug h225 events"
and if you are not sure wich dial peer you are matching do a debug voice ccapi inout just to double check it.
Regards,
Luis Sandi
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide