I am having problems with getting caller id to show up on pstn incomming calls. The IOS version is c1700-sv8y-mz.122-15.zj3.bin. I have researched caller-id and it requires that "caller-id enable" be set under the voice-port, however the command is not there. I also tried to set remote-party-id under sip-ua, but when I do a show run, I do not see the command. Is my ios not supporting caller id or might it be the wvic-1mft-t1 card that is not supporting the caller id. Any help is appreciated!!!! Part of the config is below:
controller T1 0/0
framing esf
linecode b8zs
pri-group timeslots 1-24
interface Serial0/0:23
no ip address
no logging event link-status
isdn switch-type primary-ni
isdn incoming-voice voice
no cdp enable
voice-port 0/0:23
no vad
no comfort-noise
dial-peer voice 7 pots
preference 1
destination-pattern .
direct-inward-dial
port 0/0:23
forward-digits 10
dial-peer voice 600 voip
description Match All
preference 1
destination-pattern .
session protocol sipv2
session target ipv4:xxx.xxx.xxx.xxx:5060
session transport udp
dtmf-relay rtp-nte
codec g711ulaw
no vad
