02-14-2013 02:34 AM - edited 03-16-2019 03:42 PM
Hi ,
I am using CUCM 8.5.1(10000-26)
when connected to Publisher and go to Serviceability then service activation , Feature services or Network services of the subscriber , an error appears telling can't connect to remote node .
same from Subscriber side .
Database Replication is in "good" state
onconfig.ccm reports an error "The onconfig.ccm file on x.x.x.x does not match the publisher."
Any Advise ?
02-14-2013 03:32 AM
Dear
please cli command to check the relication , you must check that each node should have a replication status of two (2).
use this command (Utils dpreplication runtimestate) and please check the output.I do not see this eror before , but if you did not get a solution , ithink t open a TAC with Cisco. I think the onconfig.ccm file on x.x.x.x does not match the publisher (it is a problemm in linux) , i think the /opt/informix/etc directory.
Thank you
please rate if this help
05-20-2014 10:05 AM
hi, I have this issue also on a CUCM 8.6 cluster... did you get this resolved? if so, what di you have to do to fix it? thank you
George
05-20-2014 10:35 AM
Hi ,
can you give show network cluster output.
Regards,
Baskaran.m
05-20-2014 11:00 AM
hi,
this is the error I get whenever I attempt to access the Subscriber from the Publisher's Serviceability web page and vice versa:
Connection to the Server cannot be established(Unknown Error) |
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide