cisco 2900 sip trunk

[sokolmukaj]

Im trying to configure a sip trunk with my isp on a 2900 series. Need help

Sent from Cisco Technical Support iPhone App

[sokolmukaj]

now its 404

The Call Setup Information is:

Call Control Block (CCB) : 0x2CD73768

State of The Call        : STATE_DEAD

TCP Sockets Used         : NO

Calling Number           :

Called Number            : 35552901060

Source IP Address (Sig  ): 192.168.207.77

Destn SIP Req Addr:Port  : 80.78.66.70:5060

Destn SIP Resp Addr:Port : 80.78.66.70:5060

Destination Name         : 80.78.66.70

Jan 17 21:07:11.955: //13323/B2DC8DC79CDF/SIP/Call/sipSPIMediaCallInfo:

Number of Media Streams: 1

Media Stream             : 1

Negotiated Codec         : g729br8

Negotiated Codec Bytes   : 20

Nego. Codec payload      : 18 (tx), 18 (rx)

Negotiated Dtmf-relay    : 0

Dtmf-relay Payload       : 0 (tx), 0 (rx)

Source IP Address (Media): 192.168.207.77

Source IP Port    (Media): 24754

Destn  IP Address (Media): 80.78.64.16

Destn  IP Port    (Media): 23024

Orig Destn IP Address:Port (Media): [ - ]:0

Jan 17 21:07:11.955: //13323/B2DC8DC79CDF/SIP/Call/sipSPICallInfo:

Disconnect Cause (CC)    : 1

Disconnect Cause (SIP)   : 404

[Chris Deren]

404 indicates unallocated number, so the 150 extnesion does not appear to be found. I see you have cor lists defined, but since you did not post the full config, can it be that COR list is blocking the call?

Not, that it matters here, but why are you using g729br8 codec, and not g729r8?

[sokolmukaj]

if i change codec ?

Sent from Cisco Technical Support iPhone App

[sokolmukaj]

No the corlist is not blocking anything on any dial peer

Sent from Cisco Technical Support iPhone App