03-16-2016 06:42 PM - edited 03-17-2019 06:16 AM
Hi everyone,
I configured a HP Procurve 5406Rzl2 switch chassis so some users can be migrated from an existing Cisco switch (managed by 3rd party) to the new HP one. We have two phones connected, both 7945Gs, one V4 and the other V16. After running through the really detailed guide from HP http://pro-networking-h17007.external.hp.com/docs/interoperability/Cisco/4AA2-2301EEE.pdf and implementing -
cdp mode pre-standard-voice
lldp config A2-A24,B2-B24 medTlvEnable network_policy
lldp config A2-A24,B2-B24 medTlvEnable capabilities
I managed to register the V16 phone successfully. The V4 phone I believed was registered, but returning today and it's reporting as unregistered.
I've disabled PoE, reset the port, added poe-lldp-detect enabled also, but no success re-registering the phone.
The basic topology is [Call Manager] -- [Core Procurve] -- [Access Procurve (5406Rzl2)] -- Phones. Both phones are receiving IP addresses according to CDP and LLDP neighbours. Show CDP and LLDP give identical information (bar MAC and IP of course).
If anyone has any ideas that would be great.
Thanks in advance,
KJ
03-16-2016 06:45 PM
Have you enabled CDP and configured a voice VLAN so the phones can dynamically insert themselves into the site voice vlan?
03-16-2016 06:54 PM
Hi Philip,
Thanks for the quick response, this is the response when entering show lldp info remote A7 (phone not registering)
As far as I can tell the phone has been told what VLAN is voice.
# show lldp info remote a7 LLDP Remote Device Information Detail Local Port : A7 System Capabilities Supported : Remote Management Address ------------------------------------------------------------------------------ System Capabilities Supported : bridge, telephone Remote Management Address MED Information Detail |
On the phone this is working, the output is identical (bar IP address and MAC/name of course).
I'll post on the HP forum also.
KJ
03-17-2016 04:37 PM
Looks like I've had initial success with a factory reset of the handset.
Will move some more across and watch for the results.
03-30-2016 05:54 PM
We've found differing results with the hardware version of 7945 phones.
Of the V4, V8 and V16s -
V4 - initial success after factory reset with registration and call capability. Once rebooted, fails with "registering"
V8 - initial success after factory reset with registration and call capability. Once rebooted, some continue to work, some fail
V16 - initial success after factory reset with registration and call capability. Once rebooted, more continue to work, less fail
I have logged a case with HP who so far haven't been able to discover any issues with configuration (CDP neighbors is on in rxonly mode, but the phones are configured for LLDP-MED).
Any thoughts?
03-16-2016 06:46 PM
You might be better off asking this question on an HP switching forum rather than a Cisco one.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide