Cisco 8831 phone not getting registered with CUCME 11.6

[Venkatesh.saladi3]

I am trying to register 8831 phone with CUCME 11.6 

Below is my config. But the phone is not getting registering. Any ideas !!!

voice register global
mode cme
source-address ******* port 5060
max-dn 100
max-pool 100
load 8831 sip8831.10-3-1-16.loads
tftp-path flash:
file text
create profile sync 148945114458225A
auto-register
!
voice register dn 1
session-server 1
number 2999
name Conference Room
label Conf Room
voice register pool 1
busy-trigger-per-button 1
id mac AC44.F212.C361
type 8831
number 1 dn 1
dtmf-relay sip-kpml
username conference password 12345
codec g711ulaw
no vad

[chevymannie]

Is your dhcp setup for option 150 to point to the IP of the CME router?

[Venkatesh.saladi3]

Yes it is setup correctly

[Venkatesh.saladi3]

Guys any suggestions for this!!!!

[critchey880]

Did you no create the profile and then create the profile to get the config file made?  Did you run a debug tftp to see if the phone is grabbing the config files or if it is asking for something it can't find?

[Wilson Samuel]

Hi,

Please check if you have SIP Registrar enabled

sip
  bind control source-interface XXXX
  bind media source-interface  XXXX
  registrar server

sip-ua
 retry invite 2
 timers trying 150

Regards

Wilson Samuel