Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a UC560 that was working fine, but after a power outage the CUE module just says “Voicemail System is Unavailable. Try again later.” When I session into the module and do a show run, I see the error below after the config finishes scrolling: ...
We recently deployed three AIR-CAP2702E-B-K9 APs to our 5508 controller. The APs are in areas where there are several users, however the users are locked on to APs in other locations. Even if you stand right under it. Has anyone else had experienc...
I'm working on getting ISE Guest authentication on a WLC working and ran into an issue. The guest network is on a totally isolated network from production. I was wondering if anyone ever setup ISE with one interface for management and one interface...
Wanted to make sure I had my syntax right for this. I'm trying to forward a port say 8030 from my outside interface to a host on the inside on 3389.
Here's what I have so far
object network 1.1.1.1
host 1.1.1.1
nat (inside,outside) static interfa...
Sorry for the late response. None at all. The only way we can get it to work is when we tunnel all traffic. They think it's a bug of some sort. The engineer from the AAA team and the one from the ASA team that I have been working with are suppose...
