02-24-2017 04:13 AM - edited 03-17-2019 09:38 AM
I am trying to register 8831 phone with CUCME 11.6
Below is my config. But the phone is not getting registering. Any ideas !!!
voice register global
mode cme
source-address ******* port 5060
max-dn 100
max-pool 100
load 8831 sip8831.10-3-1-16.loads
tftp-path flash:
file text
create profile sync 148945114458225A
auto-register
!
voice register dn 1
session-server 1
number 2999
name Conference Room
label Conf Room
voice register pool 1
busy-trigger-per-button 1
id mac AC44.F212.C361
type 8831
number 1 dn 1
dtmf-relay sip-kpml
username conference password 12345
codec g711ulaw
no vad
02-24-2017 01:38 PM
Is your dhcp setup for option 150 to point to the IP of the CME router?
02-27-2017 03:08 AM
Yes it is setup correctly
02-28-2017 11:30 PM
Guys any suggestions for this!!!!
03-10-2017 09:33 AM
Did you no create the profile and then create the profile to get the config file made? Did you run a debug tftp to see if the phone is grabbing the config files or if it is asking for something it can't find?
03-10-2017 10:46 AM
Hi,
Please check if you have SIP Registrar enabled
sip
bind control source-interface XXXX
bind media source-interface XXXX
registrar server
sip-ua
retry invite 2
timers trying 150
Regards
Wilson Samuel
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: