12-04-2018 02:59 AM
Dears,
I have one Cisco ATA 190 device connected on my HP printer and
it's working fine .
now i'm trying to add ONE more FAX number to the same ATA 190
but it's not working !
is it possible to have 2 fax number working on one ATA 190 device or not ?
if yes kindly HOW !
Solved! Go to Solution.
12-04-2018 11:41 AM
Hello,
If you are using CUCM then you may check the following link on "Configuring the ATA 190":
Please check the following:
Configuration
1. On the Cisco ATA 190 web page, go to Voice > Line 2 > Line Enable.
2. Choose yes to enable or no to disable.
Click Submit. Wait for 40 seconds for the change to take effect.
Hope it helps,
G
12-04-2018 08:01 PM
12-04-2018 11:41 AM
Hello,
If you are using CUCM then you may check the following link on "Configuring the ATA 190":
Please check the following:
Configuration
1. On the Cisco ATA 190 web page, go to Voice > Line 2 > Line Enable.
2. Choose yes to enable or no to disable.
Click Submit. Wait for 40 seconds for the change to take effect.
Hope it helps,
G
12-04-2018 08:01 PM
05-08-2020 02:46 PM
Dear ,
Could you please help me to clear below as am facing to setup FAX by using Cisco ATA 190.
the ATA Registered with CUCM
1. How you configured FAX with Cisco ATA, is your line SIP or PSTN line
2. Will it possible to have FAX Service over SIP ,
Regards,
FARIS
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide