Cisco CME intergration with Panasonic

[Ali Bahnam]

Dears,

I have a cisco CME version 8.5 installed on cisco 2901 Router, and a panasonic PBX, my question is can I integrated the panasonic with my CME where as I know in case I have two CME I will go to configure Dial peers but now what should I do for this integration??

Appreciate your support                 

[Anas Abueideh]

Hi,

if you have FXO card installed on your router, you can use it to integration with panasonic.

at this integration you need to create pots dialpeers. the dial-peer destination numbers should match the dial plan of panasonic.

HTH

Anas

please rate if it is helpful

[Ali Bahnam]

Thank you Anas,

The Panasonic have an IP and connected to the internal network, I'm looking to configure dial peers VOIP not pots but do you have any idea how this will be configured on panasonic side.

Thanks,

[Anas Abueideh]

Hi Ali,

what is the supported voip protocol in panasonic, h323 or SIP ?

you need to configure voip dialpeer pointing to panasonic with proper destination pattern.

HTH

Anas

please rate if it is helpful

[Ali Bahnam]

Hi Anas,

If the panasonic prtocol is H323 will be no problem the CME dial peer will configure as below:-

dial-peer voice 121 voip

translation-profile outgoing prefix

destination-pattern x..

session target ipv4:192.x.x.x

dtmf-relay h245-alphanumeric h245-signal

but if the panasonic protocol is SIP the configuration on CME will be as below:-

voice service voip

ip address trusted list

  ipv4 0.0.0.0 0.0.0.0

allow-connections h323 to h323

allow-connections h323 to sip

allow-connections sip to h323

allow-connections sip to sip

supplementary-service h450.12

no supplementary-service sip moved-temporarily

no supplementary-service sip refer

sip

  registrar server expires max 250 min 200

  no call service stop

dial-peer voice 2000 voip

destination-pattern y...

session protocol sipv2

session target ipv4:172.x.x.x

dtmf-relay sip-notify

codec g711ulaw

no vad

So please can you advise for the above if the two options are right or not??

Thanks

[Anas Abueideh · Accepted solution]

Hi Ali,

the above dialpeers are correct. I think you need to add "incoming called-number ." under the voip dialpeers so you can receive calls from panasonic.

HTH

Anas

please rate if it is helpful

[Ali Bahnam]

Thank you

[peternnaji]

Hello Anas,

What if you have the Panasonic PBX on one location and the CME on another location, but have an E1 connection between both locations?

How would this work?

Peter.

[Tagir Temirgaliyev]

it depends what cards are in your panasonic pbx.

we have e1 pri in 2911 connected to e1 pri in panasonic