CME 79XX Web Access Enabled = No

[Gerald Chong]

How can I change the handset Web Access Enabled to YES with CME7.1 ?

[Aaron Harrison]

Hi

You can enable this for all phones like as follows (this will just insert the webAccess parameter into the vendor specific section of the XML config file the phones load as they boot - the webAccess bit will be case sensitive).

Telephony-service

Service phone webAccess 1

Create cnf-files

Then restart your phones...

Regards

Aaron

Please rate helpful posts...

[Gerald Chong]

Yes, that work correctly.

[Aaron Harrison · Accepted solution]

Hi

Good to hear..

Please help to identify useful content in the forums by marking questions as 'answered' if you have received a suitable response..

https://supportforums.cisco.com/docs/DOC-6212

Aaron

[rmartin001]

CME version 7.0.0

Had to change "service phone webAccess" value to "0" so = enable. "1" = disable.

Tested with "1" and it was disable on phones 7960 and 7962. Tried with latest firmware also (7960 at 8.1.2) (7962 at 9.0.2).

[Rauf Mammadov]

I have CME versin 8.8, "service phone webAccess=0" command enabled Web Access, but 1 disables it.