CME 8.0 with 6911

[gpsriramdc]

Hi ,

As per cisco compatibility chart of CME 8.0 6911  phones is supported.

But when i checked the type in the ephone it's not available.currently we not able to register the phone with CME.

Please put a light on this.

Thanks

[linuxchild]

Hi

I had the same issue , I had to upgrade to 8.1 I think

Regards

[nitsinha]

Check the CME roadmap below

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmeroad.html

6911 is supported from CME 8.1

Cisco Unified CME 8.1
8.1	Toll Fraud Prevention	Enables Toll Fraud Prevention on Cisco Unified CME to secure the Cisco Unified CME system against potential toll fraud exploitation by unauthorized users.	http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmetoll.htmlConfiguring Toll Fraud Prevention
	Enhancements to SIP Phone Configuration	Allows you to verify SIP phone registration process, remove global registration parameters, and display details on phones that attempted to register with Cisco Unified CME and failed.	Cisco Unified CME Commands: show presence global through subnet.
	Support for Cisco Unified 6901 and 6911 SCCP IP Phones	Adds support for new SCCP IP phones 6901 and 6911.	Ephone-Type Parameters for Supported Phone Types

HTH

Regards

Nitesh

PS:Pl rate helpful posts