CME setup

[r.robins]

Can anyone out there help me.

I have configured a 2851 at home for 6 IP phones with voice mail on the installed CUE module.

I have a 4 port analog FX module and I want to be able to dial outbound for all numbers via port 0/0 and all inbound calls to the DID number xxxxx860985 to go to a huntgroup.

Easy on the CUCM which I am used to but I have no experience on CME.              

Can antone out there help with dial plans etc

[Amer rajai Sha'er]

Hello,

For the incoming , i am sure it will come to one port so on the voice port config , config this :

voice-port 0/1/0
supervisory disconnect dualtone mid-call
timeouts call-disconnect 5
timeouts wait-release 5
timing hookflash-out 500
connection plar XXX

i assume here XXX is the hunt number.

For the outgoing use this dial-peer

dial-peer voice 121 pots
destination-pattern 00T

direct-inward-dial
port 0/1/1
prefix 00

Amer