CME startup configuraiton

[welaish77]

Can anybody post the startup configuration for a basic CME with PRI lines(vwic t1/e1). 12 phones only.

[paolo bevilacqua]

Do telephony-service setup and it will build the basic config. for pri, you need to know how many digits DID you have and how your extensions are.

[welaish77]

thanks for your prompt reply i will try this. attached is the PRI settings from our PSTN.

also if you have link for the basic setup configuration. please post it.

[paolo bevilacqua]

network-clock-participate wic X

network-clock-select E1 0/X/0

card-type E1 X

controller E1 0/X/0

framing no-crc4

pri-group

For the rest need to know how your extensions looks like.

[welaish77]

My extentions is 700 till 899

but i will be only using 12 phones with pilot number of 777.

thanks for your prompt reply and help

[paolo bevilacqua]

If you only want to connect all and any call to 777, just configure "connection plar 777" under voice port x/y/z.

As an appreciation to those providing answers, please rate useful posts with the scrollbox below!

[welaish77]

no i mean this will be the main number for the office. thats it.

[paolo bevilacqua]

So how do you want things to work ?

[welaish77]

sorry for being late. every extensions can receive calls from outside and got a unique number. thats it.

[paolo bevilacqua]

Under telephony service

dialplan-pattern 1 04xxxxx.. extension-length 3 extension-pattern 7..

xxx has to be replaced with your number. If that doesn't work you need to take "debug isdn q931" with "term mon" for an incoming call.

[welaish77]

thanks if i faced any problem i will get back to you. do u have any guide or weblink for this, it will help fill the gaps.

thanks

[paolo bevilacqua · Accepted solution]

Really this is an area where there is no substitute for experience and logical thinking.