Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi folks,Here is my topology:CCME4.2 => SIP trunk => ISP-SIP-ProviderIs there a possibility to suppress the caller number over the SIP-trunk (like clid restrict on the BRI-interface)?Thanks.Greets,Norbert
I am looking for a VoIP device that has analog speaker outputs so I can use it to page employees in a large warehouse. There are no phones in the warehouse just speakers with simple audio grade wire running back to my phone room. Does such a device...
I have a requirement where analog phones are connected to the FXS ports on the 2811 router. Is it possible to have one analog phone auto-ring (PLAR) two other analog phones at the same time?Do I need CME to achieve this or voice-port and dial-peer co...
CME Config with FXOwhen grabbing a line, 9.1 if you turn the volume up you get hum on the line.on one of the FXO's you get a crackle and a buzz when talking.Had a tech check all the lines before they tie into the router and everything works ok. Also...
I am having a problem forwarding to an LD number in CCM 4.1.3. This only works when the caller is internal or within the same local area code as the forwarded phone.Anytime a caller from outside the area code calls in, and is forwarded to the LD num...
Hello,I have a CallManager (v.4.1.3) cluster in the UK and a CME (v4.0) in the USA. They are connecting by a route plan direct to the CME which is setup on the CCM as an H.323 gateway. At present we only dial extension numbers in the USA from the U...
Our Customer have 01 CallManager in Genebra and another in Brasil. Each CallManager is the Cluster, and He need to have a only one database. There is configuration that could be to do in the CallManager for unified the database or it's necessary a on...
Hi all!I have an old MCS-server with 4.2. I want to byu new MCS-server and upgrade my CCM 4.2 to new hardware and new version UCM 5.1. What should I do to perform migration from old hardware and old CCM to new hardware and new UCM? Can you post step-...
Hi pros,I was wondering if it was possible to use my cisco 2811 as a fax server ?or at least is it possible to receive fax with it (to email) and send fax with the fax machine, on same line number ?thanks in advance
Hello,What would justify a migration from CCM 4.1.3 to CUCM 6.1 ? On both product life cycle and features.Could anyone help?thanksmartin
Hi all,unfortunately, I have no idea, how to achive the following - probably somebody has a good idea...We're running a CISCO Callmanager 4.2(3) and a GSM gateway to route calls to the GSM network via this gateway rather than through our PSTN provide...
Hi all, A customer plans to relocate a CUCM6.1 publisher to a new site with a new hardware and a new IP address. Hence, the IP address should be changed. According to replacing a single server or a cluster for CUCM 6, all subscribers should be rei...
Is there any benefit to compressing the control traffic o\ver the WAN. Have a customer who is investigating WAN acceleration boxes and would like to know if compressin VoIP control traffic is beneficial.
I have a customer whose host site was affected by a tornado recently. The host site is pretty much flattened, and they are unable to get to the site to assess the damage. Anyway, they have a remote site that is in SRST, and the site is working fine, ...
Hi Engineers,One of my customer has a requirement ip tel connectivity through remote connection.(DSL)They thinking a cheaper solution which is DSL(CONFIGURED VPN).The remote phones will register to a single site.Could you please let me know if there ...
