CME with 7915 expansion module

[Ahmed Awida]

Hi Guys,i have 7962 phone attached to it two 7915 modules each with 12 buttons so the total is 24 buttons.

what is the configuration commands needed to show the 2nd page on each module?I mean i need to add more than 24 speed dials .

Thanks in advance.

[Gregory Brunn · Accepted solution]

Check out

https://supportforums.cisco.com/thread/2113741

[Ahmed Awida]

Thanks for the help.Good post.

[paolo bevilacqua · Accepted solution]

As CLI question mark would have hinted, and as explained in manual:

type xxx addon 1 7915-24 2 7915-24

[Ahmed Awida]

Thanks but i didn't find something noted in cme guide that i have to use 24 instead of 12 to make it works.

[paolo bevilacqua]

It should have been in command reference, but it's even there. But in some document must be.

Thank you for the nice rating and good luck!