conference call

[syed baseeruddin]

can any body explains this commands how it work and how to enable in router

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

maximum sessions 3

associate application SCCP

!        

dspfarm profile 2 conference

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

codec g729r8

codec g729br8

maximum sessions 2

[ericdolton]

That is part of the IOS based conference bridge configuration.  In short, cisco call manager software conference bridges can only do G.711ulaw, so in order to allow callers requiring G.729 or any other codec (see the list of codecs above) to join a conference call, you need to setup a hardware based conference bridge on a router with DSP's.   This hardware bridge will register with call manager and be assigned to mrg's and mrgl's. The max sessions will vary depending on how many DSP you have available in your router. 

This link explains it in detail.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a008084fe1f.shtml

[syed baseeruddin]

hi

we are using in these commands in srst router 2921 can you send link of these router

these configuration we can use srst router and call manger also

[paolo bevilacqua]

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_cr.html