Configuration of E1/T1 to send data

[fayiz husain]

Hi,

How to configure E1/T1 to send data? Can anyone give me the commands?

[ronpatel · Accepted solution]

HI

You can follow below link for configuring it from data networks

http://www.cisco.com/en/US/docs/ios/12_1/12_1xd/feature/guide/t1e1wan.html

Regards
Ronak Patel

Rate all helpful post by clicking stars below the answer.

[chrysostomos1980]

Hi

Can you describe the call flow?

It will help us better

Regards

chrysostomos

[fayiz husain]

Hi,

I need the commands to configure E1/T1 as WAN link?

[ronpatel · Accepted solution]

Hi

You can use above document or below

http://www.cisco.com/en/US/docs/routers/access/1700/1721/software/feature/guide/t1e11721.html

Main command is channel-group 0 timeslots 1-31

Regards
Ronak Patel

Rate all helpful post by clicking stars below the answer.

[chrysostomos1980]

Hi

+5 to you Ronak

Pls follow the link that Ronak Provided

Regards

chrysostomos

[Terry Cheema · Accepted solution]

Fayiz,

As Ronak has provided you the link, you need to configure Controller, then configure your Serial interface - assign it ip address/encapsulation depending on what you are trying to achieve.

For example: you can use to connect point to point link between two routers or use it as a backup solution or may be even connect to frame relay cloud (which is pretty much obsolete) etc. along with more options.

The exact commands will be according to your design what exactly are you trying to achieve, connecting two offices or configuring backup link, etc - its not very complicated. You can refer to the document provided or ask here again if you come across any issue.

-Terry

Sent from Cisco Technical Support iPad App