07-20-2013 12:03 AM - edited 03-16-2019 06:27 PM
Hi Team,
I would like to know, How to configure Cisco VG224 using MGCP
1.What Configuration will do on VG 224
2.What Configuration will do Call Manager 8.6
Regards,
Praful S.
07-20-2013 12:27 AM
You should use SCCP with Vg224 on CM. Not MGCP.
07-20-2013 12:21 PM
Config is pretty much the same as for any ISR if you want MGCP on the VG224
Sent from Cisco Technical Support iPad App
07-22-2013 05:37 AM
Paolo-
It is common to configure FXS ports for MGCP control since SCCP doesn't support protocol-based T.38 switchover. This is typically required (as opposed to NSE-based switchover) in environments that have a third-party fax server.
For the original question:
ccm-manager mgcp
ccm-manager music-on-hold
ccm-manager config server
ccm-manager download-tones
ccm-manager config
mgcp
!Possibly related commands if the hardware will be doing faxing, esspecially T.38v0.
mgcp modem relay voip mode nse gw-controlled
mgcp package-capability fm-package
mgcp fax t38 ls_redundancy 2
mgcp fax t38 hs_redundancy 2
mgcp package-capability fxr-package
no mgcp fax t38 inhibit
Please remember to rate helpful responses and identify helpful or correct answers.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide