Solved: Configure Speed dial on Analog phone

Saima Harris · ‎01-10-2013

Hi,

How can I configure speed dial on an Analog phone when you are using VG224 and Call Manager 8.6.

Here is configuration I tried but I'm stuck after that, Is there anything else that needs to be configured on VG224 and also what would be the CM config :

VG224-1(config)#stcapp call-control mode feature
VG224-1(config)#stcapp feature speed-dial
VG224-1(config-stcapp-fsd)#digit 1
VG224-1(config-stcapp-fsd)#prefix *
VG224-1(config-stcapp-fsd)#exit

Thanks

Saima

giftonabel · ‎01-14-2013

Hi Saima,

It doesn't matters what kind of anaolg phone you have, unless it is connected via the VG224, follow the below steps to configure it.

Assuming that you have already added VG224 in CUCM, and have assigned the DN to the analog ports.
Go to your CUCM administration Page and navigate to User Management --> End user --> Search the user --> In controlled Devices, search the DN and select the DN/analog device that you want to associate with this user.
In Permission information, assign the "Standard CCM End users" to the groups.

Now access the URL https://:8443/ccmuser, login with the users credentials.
Go to User Options --> Device --> Click on Speed Dials and now start configuring it.

If this helps, please rate the post.

Regards,

Gifton Abel.

View solution in original post

giftonabel · ‎01-13-2013

Hi,

You missing the below highlighted command ,

Router#stcapp feature speed-dial

digit 1

prefix *

speed dial from 1 to 9

Router# show stcapp feature codes

!

stcapp feature speed-dial

prefix *

speeddial1 *1

speeddial2 *2

speeddial3 *3

speeddial4 *4

speeddial5 *5

speeddial6 *6

speeddial7 *7

speeddial8 *8

speeddial9 *9

!

Now configure the Speed dial numbers in the ccmuser page.

Note: to support upto 99 speed dials, need to configure

!

Router#stcapp feature speed-dial

digit 2

!

HTH,

Gifton Abel.

Saima Harris · ‎01-14-2013

Thanks for the information Gifton.

Ho do I configure speed dial numbers in CM (ccmuser page), providing its an Analog Astra phone.

giftonabel · ‎01-14-2013

Hi Saima,

It doesn't matters what kind of anaolg phone you have, unless it is connected via the VG224, follow the below steps to configure it.

Assuming that you have already added VG224 in CUCM, and have assigned the DN to the analog ports.
Go to your CUCM administration Page and navigate to User Management --> End user --> Search the user --> In controlled Devices, search the DN and select the DN/analog device that you want to associate with this user.
In Permission information, assign the "Standard CCM End users" to the groups.

Now access the URL https://:8443/ccmuser, login with the users credentials.
Go to User Options --> Device --> Click on Speed Dials and now start configuring it.

If this helps, please rate the post.

Regards,

Gifton Abel.

Saima Harris · ‎07-08-2013

Thanks for your help .

Worked like a charm

Saima