Configuring new E1 MFT

[simonmossman]

Hi all

Can you please confirm the correct configuration for a new E1 card install. Currently I have 1 30 channel E1 installed in the 3825 VG. I am assuming all I will have to do is add the controller and timeslots and I should be good to go. Then just add the translation patterns in the CUCM

Look forward to a reply

thanks

Simon

[KonradStepniewski]

It should be enough if you use MGCP as protocol. Still keep in mind you need DSP to use this E1 card.

Check your show diag DSP info with DSP calculator: http://www.cisco.com/cgi-bin/Support/DSP/cisco_prodsel.pl

rate if this help

[simonmossman]

Thanks Konrad

The DSP tool is cool